Automobile designers regulate high current devices or systems, such as the starter or fuel system, with a smaller amount of current controlled through a series of relays or switches. In Honda Accords manufactured between 1986 and 1997, the main relay serves as the "middle man" helping other devices to control the ignition and fuel system. If your Accord won't start, then you may have a damaged or broken main relay.
Instructions
1. Verify that the problem doesn't stem from the fuel pump, ignition or any other source.
2. Disconnect the battery and find the main relay. Typically, the main relay on a Honda Accord rests behind the dashboard to the right or left of the steering while with accessibility up under the dashboard or behind the steering column access or dash panel. The main relay should be marked with the words "RELAY ASS'Y MAIN." If you have difficulty locating it, then confirm the exact location using the manufacturer's manual for your specific model year.
3. Pull the main relay from its location. You may need to push aside wires or devices or remove devices, such as the cruise control box, that block the main relay. Use your ratchet or wrench to remove any nuts and bolts (ratchet counterclockwise) attached to a device to expose the main relay or any that hold the main relay in place.
4. Unplug the Honda Accord's relay from the main relay socket, which is the base connected to the wiring. Keep in mind that the socket attaches to the relay via a tab that locks the relay to the socket. Without touching any of the wires, push in the tab to release the relay or use a pocketknife to pop the relay from the socket base.
5. Pop the new relay firmly into place by gently gripping the relay socket base and pushing the relay into it without touching the socket wiring or the solder components of the relay. Damage to the wiring's connection to the socket or to the solder can occur if either come in contact with your hands. Also, keep in mind that your new relay must fit snugly within the socket as a loose relay can overheat or cause melting of the outer casing when current runs through it.
6. Reverse the steps you took to remove the relay. Remember to not only securely tighten all nuts and bolts, but to also tape together with your electrical tape any loose or hanging wires.
7. Reconnect the battery. Start your car to confirm that your new relay works.
Tags: main relay, Honda Accord, relay from, relay socket, fuel system, mind that, nuts bolts
